Dual Support / Off-The-Shelf / 600 Series / HD641

HD641

Load Rating: 760 lbs

Swing Radius: 36.3"

Max Torque: 5,400 in-lbs

Easy Crank: 2,000 in-lbs

The Model HD641-IND15-P8-B045 shown is typical and representative of the HD641 Models.

To receive a CAD model or a quotation:

Configure a Flotron Fixture
The maximum distance between mounting interfaces is directly related to the main beam length. Specify the distance between mounting interfaces to be at or slightly larger than the length of the part-to-be-handled. The fixture can be adjusted to accommodate smaller length parts, however, the main beam(s) extending from each end frame may be inconvenient. For more information see the 600 SERIES OPTIONS page and 600 SERIES CREATING A MODEL NUMBER pdf.
Addition of an optional SR or DR gearbox decreases the vertical riser adjustment from 8" to 6" and increases the minimum trunnion height from 35.3" to 37.3".
A smaller than standard swing radius may be recommended for some applications. See the "Technical Section" under "Holding Fixture Safety" on page 3 of 7 concerning "Unexpected Accident Loads" and the chart on page 4 of 7 referring to "Maximum Recommended Swing Radius" * Note: Adjusting unit to dimensions smaller than 30" can cause tip over due to small footprint.

Product Features

  • Safety Factor: 3 for Yield & 5 for Ultimate
  • Rated Load Capacity:
    • Dynamic, 0″ eccentricity: 760 lbs. (345 kg.)
    • Dynamic, 5″ eccentricity: 760 lbs. (345 kg.)
  • Operating Temperature: +32 to +104 °F (0 to +40 °C).
    • Contact factory for special applications with extended operating temperatures.
  • Trunnion Interface/Mount/Clamp Options:
    • Angle Interface
    • Mounting Plate Interface
  • Materials: Steel construction
  • Finish: Flotron Blue powder coat with selected parts zinc plated.
  • Gearbox: 60:1 ratio with 12″ diameter crank
  • Choice of Main Beam Length
  • Main Beam Ball Lock Pins: Reliably prevents End Frames from slipping on Main Beams
  • Casters: 5″ diameter x 2″ wide wheel with polyurethane tread, sealed swivel bearing and Tech-lock brake
  • A smaller than standard swing radius may be recommended for some applications. See the “Technical Section” under “Holding Fixture Safety” on page 3 of 7 concerning “Unexpected Accident Loads” and the chart on page 4 of 7 referring to “Maximum Recommended Swing Radius”
  • Optional Trunnion Interface/Mount/Clamp
  • Optional Index Plate
  • Optional Index Stops
  • Optional Gearboxes incorporating heavy duty, low backlash and stairstep resistant features
  • Optional Split Pillow Block Trunnion Bearings
  • Optional finishes for clean room compatibility
  • Optional Ground Lug and Drag Chain for use in electrostatically protected areas (EPA’s)
  • Optional Main Beam Lengths
View 600 Series Options

As Flotron is constantly improving products and methods of manufacturing, we reserve the right to modify and/or change design or specifications without notice. Please contact Flotron for verification of critical dimensions and specifications.

For 600 Series - Creating a Model Number pdf click here

For clarification of terms or phrases, please see the Holding Fixtures Definitions page.